Best executive courses in Industry and Manufacturing in United Arab Emirates

ICTD International Centre for Training and Development

Fans and Blowers: Performance, Measurements & Maintenance

The course is devoted to design features, efficiencies, operating characteristics, reliability and maintenance implications of fans and Blower. Topics include terminology, component operation, and testing and repair of. Upon completion, students should be able to assess manufacturer...

ICTD International Centre for Training and Development

Trace Analysis: Applications, Methodologies, Techniques, Sample Preparation, Measurement, Removal & Reporting

Trace Analysis measurements play a key role in many areas of interest to industry and commerce, to governments, and to individuals. For example, the development and production of many new materials, of microelectronic devices, and of safe pesticides has been dependent on the availability of...

ICTD International Centre for Training and Development

Process Plant Start up and Commissioning

Start Up and Commissioning of new plant and equipment presents both a major technical and management challenge. Organizations personnel must familiarize themselves with new equipment, processes and technologies; develop the relevant operating and safety procedures. This course addresses in an...

ICTD International Centre for Training and Development

Current Inspection Trends in Fabrication & Plant Maintenance

ICTD International Centre for Training and Development

Introduction to the Safe Operation of High Power Systems

The purpose of this training course is to establish minimum standards to prevent hazardous electrical exposures to personnel and ensure compliance with regulatory requirements applicable to electrical systems. Working on the equipment in a de-energized state is required unless de-energizing...

ICTD International Centre for Training and Development

Practical Safety Instrumentation & Emergency Shutdown Systems for Process Industries

This course will provide the participants with the knowledge necessary to gain and enhance their operational aptitude in the area of safety systems. It will cover the operation and basic hardware of Safety Instrumented Systems (SIS), Total Plant Shutdown Systems (TPS), Emergency Shutdown Systems...

ICTD International Centre for Training and Development

Modern Distributed Control Systems (DCS): Practical Applications & Troubleshooting

This 5 days course will cover the practical applications of the modern distributed control system (DCS). Whilst all control systems are distributed to a certain extent today and there is a definite merging of the concepts of DCS, Programmable Logic Controller (PLC) and SCADA and despite the rapid...

ICTD International Centre for Training and Development

Machinery Alignment and Balancing

This course teaches you how to perform corrective field balancing. It is based on understanding rotor response theory, the accurate acquisition and analysis of data, and applying the best field methods for a given machine design. We thoroughly explain the nature of machinery unbalance and teach...

ICTD International Centre for Training and Development

Successful Well Completion and Workover Practices: a Practical Approach From Design to Field Operations

Well completion is considered to be one of the most critical practices for reservoir exploitation and management. During this process, the responsible personnel is tasked to optimally design and install a system that can deliver its full potential to optimize oil, gas and production without...

ICTD International Centre for Training and Development

Certified HV - MV Cable Splicing, Jointing & Termination

The range of voltage and capacity of power transmitted through cables is showing a steady increase over the years. Environmental concerns, aesthetic issues, lack of transmission corridors and difficulty in routing overhead lines in crowded human habitats are some of the reasons for the explosive...